BS-DV-228-01            Damper Vane Tool V3 (3x.8mm) without cutting tool

The Original dampers from the MMX had 4 holes at .8mm each. Decided to try and replicate the MMX surface area for the New A800R vanes, and put it on the leading edge of the vane.

There are two version of the V3 design.  Yes, two different versions.  Possibly this gives you a view into Bill's Mind!

FJ would call this version V4.

I also made a V3 3x.8mm which is similar to our current vanes (2 holes x 1mm),  .01mm difference between the two. Try starting with the V3 3x.8mm then you can use the V3 4 x.8mm. Same depth just height difference. 

*Note - must glue the original 2 holes x1mm of the vane, (U.V. Glue not included).   

Best used with Soft Springs and Type 1 B gap.

Best used in high grip scenarios